Pod-InComments version  0.9
===========================

Module for embedding POD in the comments of your config file.
With the appropriate routines to extract the whole or parts of it.


E.g., when your config file looks like:

;=head1 cpu
;
;Specifies cpu settings for normal boxes
;note that these will override factory settings!
;
;=head2 maxload
;
;The maxload setting gives an upperbound on how hard
;the CPU can be pushed.

[cpu]
maxload=4.0


then doing:

my $pod = $podparser->Pod4Section( 'cpu', 'maxload' );
will give you:

The maxload setting gives an upperbound on how hard
the CPU can be pushed.


INSTALLATION

To install this module type the following:

   perl Makefile.PL
   make
   make test
   make install

DEPENDENCIES

This module requires these other modules and libraries:

    Pod::POM

COPYRIGHT AND LICENCE

Put the correct copyright and licence information here.

Copyright (C) 2007 by Jaap Voets

This library is free software; you can redistribute it and/or modify
it under the same terms as Perl itself, either Perl version 5.8.5 or,
at your option, any later version of Perl 5 you may have available.